Elastix Allo PRI Gateway Server Bedienungsanleitung PDF herunterladen (Seite 6)

ALLO-4PRI/ALLO-4PRIe/ALLO-2PRI/ALLO-2PRIe User Manual – Version 2.0

WWW.ALLO.COM Page 4

Software Configuration

This session will provide steps for configuring signaling mode, once you are done

with the signaling mode continue with module & channel configuration.

E1/T1/MFCR2 mode settings

E1 Mode

Add “tor3e” at the end of /etc/dahdi/modules, so that while starting dahdi

driver Allo card modules will load automatically

T1 Mode

To configure the PRI card in T1 signaling mode, please add the following line

in the relevant files,

(i) Add “tor3e” at the end of /etc/dahdi/modules, so that while starting

dahdi driver Allo card modules will load automatically

(ii) Add “options tor3e e1t1override=1 # for T1 Signaling”

at the end of /etc/modprobe.d/dahdi.conf

MFCR2 Mode

To configure the PRI card in MFCR2 signaling mode, please add the following

line in the relevant files,

(i) Add “tor3e” at the end of /etc/dahdi/modules, so that while starting

dahdi driver Allo card modules will load automatically

(ii) Add “options tor3e mfcr2=1 # for MFCR2 Signaling” at

the end of /etc/modprobe.d/dahdi.conf

Note: Basically tor3e driver module installs the PRI card as E1 mode. No need to set

any options for E1 signaling mode.

• Module & channel Configuration

(i) Add “#include dahdi-channels.conf” at the end of

/etc/asterisk/chan_dahdi.conf

• Restart Dahdi

(i) /etc/init.d/dahdi stop

(ii) /etc/init.d/dahdi start

(iii) Now you can see the tor3e module also loaded.

• Generate Configuration files

(i) Type “dahdi_genconf –vvvv” to generate configuration files

(ii) Type “dahdi_cfg –vvvv” to configure the channels

Hardware LEC Module setup

This session will provide steps for updating Hardware LEC module,

1. Download the firmware for Hardware LEC module from Allo web site from this

1 2 3 4 5 6 7 8

Keine Kommentare

Elastix Allo PRI Gateway Server Bedienungsanleitung Seite 6